Pulse Width Modulation and Demodulation Manufacturer,Supplier and Exporter in India
Product Code : JA-CT-1498
The pulse width modulation and demodulation board is used to modulate a pulse carrier with a sinusoidal signal to obtain a PWM signal, and to demodulate that signal to recover the modulating signal. It has a ±6 V DC, 100 mA IC-regulated supply and is used with a 20 MHz oscilloscope (SKU JA-CT-1498).
Specifications
Listed data:
| Product | Pulse Width Modulation and Demodulation |
| SKU | JA-CT-1498 |
| DC supply | ±6 V DC at 100 mA, IC regulated |
| Mains | 230 V ±10%, 50 Hz AC; ON/OFF switch, fuse and jewel light |
| Patch cords | 4 mm spring-loaded plugs, stackable from the rear at both ends, 0.5 m |
| Other apparatus required | CRO 20 MHz |
| Circuit details | Confirmed on the quotation |
Experiments
The listed objects are:
- Modulating a pulse carrier with a sinusoidal signal to obtain a PWM signal
- Demodulating the PWM signal to recover the modulating signal
Scope of supply and ordering
The listing covers the PWM board with patch cords and operating instructions, supplied by JaincoLab; the modulator and demodulator circuit details are confirmed on the quotation.
Frequently asked questions
What does the PWM board demonstrate?
Pulse width modulation of a pulse carrier by a sinusoidal signal, and demodulation back to the modulating signal.
Is an oscilloscope needed?
Yes. A 20 MHz CRO is listed as other apparatus required.
Related products
- Analog Signal Sampling and Reconstruction
- Pulse Code Modulation and Demodulation Trainer
- Delta Modulation and Demodulation
- Frequency Modulation and Demodulation Trainer
Other products in this group are in the communication trainer range.
Request a quote
Quotations for the Pulse Width Modulation and Demodulation are prepared on request through the JaincoLab contact page. Buying under a laboratory tender? Use our tenders page.
