• +91-85699-09696

Frequency Modulation and Demodulation Trainer Manufacturer,Supplier and Exporter in India

Frequency Modulation and Demodulation Trainer

Product Code : JA-CT-1496

The frequency modulation and demodulation trainer is an FM transmitter and receiver on a single 300 x 400 mm PCB. It generates FM with varactor and reactance modulators and demodulates it with detuned resonant, quadrature, Foster-Seeley, ratio and phase-locked loop detectors, with a separate VCO circuit, a noise mixer, 8 switched faults and 78 test points (SKU JA-CT-1496).

Specifications

The FM trainer is listed with:

Product Frequency Modulation and Demodulation Trainer
SKU JA-CT-1496
PCB Single board, 300 x 400 mm
Power supply ±12 V DC, IC regulated
Modulating signal generator Sine, 300 Hz to 3.4 kHz, 0 to 5 Vpp
Modulators Varactor and reactance, each with carrier frequency adjustment
Demodulators Detuned resonant, quadrature, Foster-Seeley, ratio and PLL detectors
Mixer/amplifier 1, with gain adjustment; adds a noise input to the FM signal
Low pass filter 3.4 kHz cut-off, with adjustable-gain amplifier
VCO circuit Separate, to demonstrate the FM waveform
Amplitude limiter On board, with amplitude control
Switched faults 8
Test points 78
Power 230 V AC, 50 Hz

FM studies

The trainer covers:

  • Frequency modulation with a varactor modulator and with a reactance modulator
  • Demodulation with detuned resonant, quadrature, Foster-Seeley, ratio and PLL detectors
  • FM waveform demonstration on the separate VCO circuit
  • Effect of noise on FM detection
  • Fault finding with the 8 switched faults

Scope of supply and ordering

The listing covers the self-contained FM trainer board with operating instructions, supplied by JaincoLab.

Frequently asked questions

Which FM detectors can be compared?
Detuned resonant, quadrature, Foster-Seeley, ratio and phase-locked loop detectors.

How is noise introduced?
A mixer/amplifier with gain adjustment lets the FM signal be amplitude modulated by a noise input before demodulation.

How many switched faults are there?
Eight on-board switched faults, with 78 test points.

Related products

The communication trainer range lists further items of this kind.

Request a quote

Quotations for the Frequency Modulation and Demodulation Trainer are prepared on request through the JaincoLab contact page.

JaincoLab manufactures and exports laboratory equipment for Ministry of Education programmes, World Bank-funded tenders and United Nations projects, and has executed these supplies successfully in many countries. Contractors bidding for such tenders can contact JaincoLab for specifications, quotations and turnkey tender supply.

Last updated: September 2026

   

Office Address

Jain Scientific Suppliers
2475-84, Hargolal Road,
Ambala Cantt, Haryana, India

[email protected]

+91-85699-09696

Follow Us